![]()

Glass may look the same from across the room, but the type fitted in a window or door decides how it behaves under impact. SOS Glass Services, a glass repair company serving the Hurstville area, describes broken glass as a hazard that must be removed and replaced to keep a property safe. How severe that hazard becomes depends largely on whether the pane is safety glass or normal glass, and it’s a distinction that matters for anyone living in an older home.
What Normal Glass Is
Normal glass, often called annealed or float glass, is produced by cooling molten glass slowly so it can be cut and shaped easily. Affordable and clear, it was used widely in houses for decades. Its weakness shows when it breaks. Annealed glass fractures into large, jagged shards with sharp edges that can cause serious cuts, particularly when someone falls against a low window or a glass door.
What Makes Glass a Safety Glass
Safety glass is engineered to reduce the risk of injury when it breaks. In Australia, the two main types are toughened glass and laminated glass.
Toughened glass, also called tempered glass, is heated and then rapidly cooled. This process makes it around four to five times stronger than annealed glass of the same thickness. When it does break, it crumbles into small, blunt granules rather than long shards. It must be cut to size before toughening, as it cannot be trimmed afterwards.
Laminated glass bonds two or more sheets of glass to a plastic interlayer. If the glass cracks, the fragments stay stuck to the interlayer, so the pane tends to hold together in its frame. The interlayer also makes it harder to break through and can reduce noise and ultraviolet light.
Key Differences at a Glance
Strength is the first major difference. Toughened glass resists impact far better than annealed glass, while laminated glass is designed to stay in place even after cracking.
Breakage behaviour is the second. Normal glass breaks into dangerous shards, toughened glass breaks into small pieces, and laminated glass cracks but holds together.
Compliance is the third. Australian Standard AS 1288 sets out where safety glass is required in buildings, including doors, side panels next to doors, low-level windows, bathrooms and other areas where people are likely to make contact with the glass.
Cost is the fourth. Safety glass generally costs more than annealed glass.
Why Older Homes Need Closer Attention
Many houses in established suburbs were built before current glass requirements came into force. Child safety organisations such as Kidsafe note that many homes built before 1989 do not meet Australian safety standards for glass, as those standards were not applied retrospectively. Homes built before the mid-1970s are likely to contain very little safety glass at all. Owners are not usually required to upgrade intact glass, but replacement panes generally must meet current requirements, so a breakage or renovation is often the point at which older glass is upgraded.
How to Identify Which Glass You Have
The most reliable check is a permanent stamp, usually found in a corner of the pane. Safety glass made to Australian requirements typically carries a mark showing details such as the standard, the glass type and the manufacturer. A missing stamp does not always confirm the glass is annealed, as the mark may be hidden by a frame, but it is a reason to look more closely.
Viewing the glass through polarised sunglasses can reveal faint patterns in toughened glass caused by the heating process. Laminated glass can often be spotted by looking at the edge, where the separate layers and interlayer may be visible.
Planning Upgrades in an Established Home
Prioritising the areas covered by AS 1288 is a sensible starting point, especially doors, low windows and bathrooms in homes with children or older residents. For further information on window glass replacement and the glazing options available, readers can visit the SOS Glass Services website.
SOS Glass Services Pty Ltd
34 Verdun Street
Bexley
NSW
2207
Australia